28 EVO Installation Guide
Programming Methods 3
3.1 Paradox Memory Key
The Paradox Memory Key can copy the programmed contents of one control panel into as many others.
Note: Not to be used with UL Listed systems.
Copy to Memory Key
1. Insert the Memory Key (PMC-4) onto the control panel’s connector labelled “MEM KEY”.
2. To copy the contents to the Memory Key except zone numbering and sections [0501] to
[0532], enter installer programming mode, then enter section [4020]. (Depending on the
memory key, the labels may or may not be included.)
To copy the contents to the Memory Key including zone numbering and sections [0501] to
[0532], enter section [4021]. (Depending on the memory key, the labels may or may not be included.)
3. When the keypad emits a confirmation beep, remove the Memory Key. Remove the write protect jumper.
Download to Control Panel
1. Insert the Memory Key onto the control panel’s connector labelled “MEM KEY”.
2. To download the contents of the Memory Key except zone numbering and sections [0501] to
[0532], enter installer programming mode and then enter section [4010]. (Depending on the
memory key, the labels may or may not be included.)
To download the contents of the Memory Key including zone numbering and sections
[0501] to [0532], enter installer programming mode and then enter section [4011].(Depending on the
memory key, the labels may or may not be included.)
3. When the keypad emits a confirmation beep, remove the Memory Key.
Figure 12: Using the Memory Key
3.2 Module Broadcast
Keypads and other modules can also be programmed easily by using Module Broadcast. Once a module is
programmed, its sections can be sent to other similar modules through the combus.
Jumper ON =
Can copy and
Jumper OFF =
Cannot override
To Next Page
Loading...
