EVO Installation Guide 133
Appendix I: Warnings
FCC Warnings
IMPORTANT INFORMATION
This equipment complies with Part 68 of the FCC rules subpart D and CS-03. Inside the cover of this equipment is a label that contains, among other information, the
FCC registration number of this equipment.
notification to telephone company
Upon request, customer shall notify telephone company of particular line to which the connection will be made and provide the FCC registration number and the
ringer equivalence of the protective circuit.
FCC REGISTRATION NUMBER: 5A7CAN-22633 - AL - E
RINGER EQUIVALENCE NUMBER: 0.1B (U.S. & CANADA)
USOC JACK: RJ31X (USA), CA31A
(CANADA)
TELEPHONE CONNECTION REQUIREMENTS
Except for telephone company provided ringers, all connections to the telephone network shall be made through standard plugs and telephone company provided
jacks, or equivalent, in such a manner as to allow for easy, immediate disconnection of terminal equipment. Standard jacks shall be so arranged that, if plug
connected thereto is withdrawn, no interference to operation of equipment at customer's premises which remains connected to telephone network shall occur by
reason of such withdrawal.
INCIDENCE OF HARM
Should terminal equipment/protective circuitry cause harm to telephone network, telephone company shall, where practicable, notify customer that temporary
disconnection of service may be required; however, where prior notice is not practicable, the telephone company may temporarily discontinue service if action is
deemed reasonable in circumstances. In case of temporary discontinuance, telephone company shall promptly notify customer and will be given opportunity to
correct the situation.
CHANGES IN TELEPHONE COMPANY EQUIPMENT OR FACILITIES
The telephone company may make changes in its communication facilities, equipment operations or procedures, where such actions are reasonably required and
proper in its business. Should any such changes render customer's terminal equipment incompatible with the telephone company facilities, the customer shall be
given adequate notice to effect the modifications to maintain uninterrupted service.
GENERAL
This equipment shall not be used on coin telephone lines. Connection to party line service is subject to state tariffs.
RINGER EQUIVALENCE NUMBER (REN)
The
REN is useful to determine the quantity of devices that you may connect to your telephone line and still have all of those devices ring when your telephone
number is called. In most, but not all areas, sum of the
REN's of all devices connected to one line should not exceed five (5). To be certain of the number of devices
that you may connect to your line, you may want to contact your local telephone company.
EQUIPMENT MAINTENANCE FACILITY
If you experience trouble with this telephone equipment, please contact facility indicated below for information on obtaining service or repairs. The telephone
company may ask that you disconnect this equipment from network until problem is corrected or until you are sure that the equipment is not malfunctioning.
FCC PART 15, WARNINGS: INFORMATION TO USER
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to equipment intermittently, the user is encouraged to try to
correct the interference by one or more of the following measures: (1) reorient or relocate the receiving antenna; (2) increase the separation between the equipment
and receiver; (3) connect the equipment to an outlet on a circuit other than the one to which the receiver is connected, or (4) consult the dealer or an experienced
radio/tv technician for assistance.
CAUTION:
Changes or modifications not expressly approved by PARADOX SECURITY SYSTEMS could void the user's authority to operate the equipment.
ETL and ETLC Warnings
ETL AND ETLC INSTALLATION NOTES
The control panel (EVO) and LCD Keypad (K641) are UL listed in accordance with standard UL1023 (Household Burglar -- Alarm Systems Units), standard UL985
(Household Fire Warning Units), standard UL1635 (Digital Alarm Communicator System Units), standard UL609 (Local Burglar Alarm Units and Systems), standard
UL365 (Police Station Connected Burglar Alarm Units and Systems) and standards UL1610 (Monitoring Station Burglar Alarm Units). This equipment has the
capability of being programmed with features and connected to modules not verified for use in UL installations. To stay within these standards, the installer should
use the following guidelines when configuring the system:
• All components of the system should be UL listed for the intended application.
• If the system will be used for “Fire” detection, the installer should refer to NFPA Standards #72, Chapter 2. In addition, once installation is complete, the local
fire authority must be notified of the installation.
• This equipment must be verified by a qualified technician once every three years.
• All keypads must use a tamper switch.
• Maximum allowed entry delay is 45 seconds.
• Maximum allowed exit delay is 60 seconds.
• Minimum 4 minutes for bell cut-off time.
• The following features do not comply with UL requirements: Bypass Recall, Shabbat, Auto Trouble Shutdown, and “No AC Fail” display.
• Do not connect the primary indicating device to a relay. The installer must use the bell output.
• All modules installed on the system must be UL listed in accordance with the standards listed above.
• The metallic enclosure must be grounded to the cold water pipe.
For further details concerning the above information, refer to the UL standards listed and/or the Underwriters Laboratories Inc. Standard for Safety‘s Installation and
Classification of Burglar and Holdup Alarm Systems.
The communication medium between protected property and communications service provider shall be for the exclusive use of the protected
property and is not to be shared with other communications service provider subscribers.
To Next Page
Loading...
Need help?
General
