Parker AC30 - Page 325

Parameter Reference D-65
AC30 series Variable Speed Drive
Parameter Name
No.
Path
Default
Range
Units
Writable
Actual Speed rps
0394
Same as PNO 393
x.xx
-1500.00 to 1500.00
rev/s
NEVER
This parameter changes according to the Control Strategy:
 In Vector Control mode the parameter shows the calculated mechanical speed of the motor shaft in revolutions per second.
 In Volts-Hertz Control mode, the parameter shows the motor synchronous speed in revolutions per second.
Actual Speed Percent
0395
Same as PNO 393
x.xx
-200.00 to 200.00
%
NEVER
This parameter changes according to the Control Strategy
• In Vector Control mode the parameter shows the calculated mechanical speed of the motor shaft as a percentage of the user
maximum speed setting (100% Speed in RPM in the Scale Setpoint function).
• In Volts-Hertz Control mode, the parameter shows the electrical drive output frequency as a percentage of the user maximum
speed setting (100% Speed in RPM in the Scale Setpoint function).
DC Link Volt Filtered
0396
Same as PNO 393
x.
0 to 1000
V
NEVER
This shows the filtered voltage across the dc link capacitors.
id
0397
Parameters::Motor Control::Feedbacks
x.x
-500.0 to 500.0
%
NEVER
Current in the flux axis (Vector Control)
iq
0398
Parameters::Motor Control::Feedbacks
x.x
-500.0 to 500.0
%
NEVER
Current in the torque axis (Vector Control)
Actual Torque
0399
Same as PNO 393
x.x
-500.0 to 500.0
%
NEVER
Calculated torque, based on the Iq current.