Operation Guide 500ML Lighting Control Console
122 Programming
Release at End - The cuelist will release (Switch off) itself after hitting go another time while the last cue is being
output.
Stop at End - The cuelist will stop at the last cue and pressing the "Go" Button again does not show any effect.
Playback Order
This defines the Playback order of the cues in the cuelist. Forward is used as the
default.
Settings are:
• Forward - The cuelist will be played forwards.
• Backward - The cuelist will be played back in reversed order.
• Random - The cuelist will be played back with the cues in random order, using an algorithm which assures that no
cue will be shown twice during each cycle of the cuelist.
Outfade
This is the amount of time the cuelist will fade out for when it is switched off,
providing a smooth transition instead of just "snapping" fixtures to their default or
other output values. The default Outfade time is 2 Seconds.
Off Options
The selections are:
• Off if Overwritten - Off by default. This cuelist will switch itself off, when all of
its values have been overridden by different cuelists.
• Don't Off other Cuelists - Off by default. This cuelist will not switch off other
cuelists, even if it overrides all of the other cuelists values. This is especially useful
if you wish to create a look that temporarily overrides all attributes for some fix-
tures.
• Ignore Off All Commands - Off by default. This cuelist will not listen to "All
Off" commands, in example to the "Off all Cuelists" command in the off menu.
This may be useful for work lights.
• Skip to first cue on Off - On by default. This cuelist will skip to the first cue, when it is switched off.
• Outfade on Off only - Off by default. This is especially useful if you use a Non-Tracking cuelist.
Timing Setup Tab
Figure 225: Edit Cuelist - Timing Setup Tab
To Next Page
Loading...
