Programmer Options 87
500ML Lighting Control Console
Operation Guide
Altering Parameters Using Encoders
To change fixture parameters, select either a fixture or group of fixtures (see "Selecting Fixtures" on page 63). Select
the parameter group of the parameter to be changed - [I], [F], [C], or [B]. Repeatedly press the [I], [F], [C], or [B]
button until the toolbar indicates the desired parameters. Alternatively, just click on one of the buttons shown in the
toolbar. Using encoders (as indicated in Figure 1 on page 8), change the parameters as desired. Make sure the
Programmer Window is set to Value mode as shown in Figure 156.
Figure 156: Programmer - Values Window
Example:
• To change the pan and tilt parameters for Fixture Group 1, select Fixture Group 1.
• Press the [F] (focus parameter) key. The Programmer window will appear and the encoder labels will now read the
selected features of pan and tilt.
• To cycle through the available feature groups (i.e., from Position to Pan/Tilt speed), simply press the feature button
again or press the appropriate button on the IFCB Toolbar.
Note: To quickly toggle through values in 25% steps, just press on the Encoder knob, or touch the Encoder label on
the screen. To alter the attribute values in a finer manner, hold the [SHIFT] key pressed while turning the Encoders.
Altering Color Values Using Swatch Book
Another option to set colors is via the internal color swatch book. To open up the Swatch Book, press the Swatch
Book button found in the programmer window. Remember, to open the programmer just press either of the Attribute
Keys [I], [F], [C] or [B].
Once the Swatch book window (Figure 157 on page 88) opens, simply select the color you desire.
To Next Page
Loading...
