LIFEPAK 15 Monitor/Defibrillator
Service Manual
Troubleshooting
Therapy Service Codes
Section Menu Section Contents Back Index
134
5
a126 DE_ERROR_ADC_READ (Cannot read from ADC.)
10
a127 DE_ERROR_TEST_MODE (Must be idle to switch to test mode.)
10
a129 DE_ERROR_XFER_CABLE (Defib HW error.)
10
a12a DE_ERROR_XFER_PADDLE (Defib HW error.)
10
a12c DE_ERROR_CHG_INHIBIT (Defib HW error.)
10
a12d DE_ERROR_CHG_ENABLE_FAIL (Charge enable feedback indicates not charging.)
10
a12e DE_ERROR_BTE_FAULT (Cedar BTE Fault Line State.)
17
a12f DE_ERROR_BTE_FAULT_CLEARED (Cedar BTE Fault Line State.)
17
a130 DE_ERROR_BTE_RESET (Defib HW error.)
17
a131 DE_ERROR_NO_BTE_HW (Biphasic HW not found.)
17
a132 DE_ERROR_NO_BTE_XFER (Defib HW error.)
17
a133 DE_ERROR_BTE_CEDAR_DRV_HI (A/D high bit sticky.)
17
a201 PA_ERROR_LONG_WDT (Long watchdog timer test failed.)
15
a202 PA_ERROR_SHORT_WDT (Short watchdog timer test failed.)
15
a203 PA_ERROR_SCI_RCV (SCI received overrun, framing or parity. Unit used near high EMI causing these issues.)
15
Table 5.13—Initial Character a, Therapy Service Codes (TH)
Code Service Code Description
Corrective
Action Code
To Next Page
Loading...
