Pilz PMCprotego D.48 - Page 186

Commissioning
Operating Manual PMCprotego D.48, PMCprotego D.72
1001735-EN-04
186
INFORMATION
Recommendation: Note the sequence when switching on and switch-
ing off
Please note the correct order when switching on and switching off the servo
amplifier. Further information is provided in Chapter Normal mode.
Configuration Example
Components
} PMCprotegoD
} Motor PMCtendo SZxx with standard encoder
} Mains contactor K1 (optional)
} 24VDC power supply for control element
} 24 V power supply for motor holding brake
} Motor and encoder cable
} Brake resistor R
Be
} PC with installed commissioning software PASmotion. The current version is available
on our website www.pilz.com.