User’s Manual of WGSD-10020 Series
Parameters:
<port_list>: Port list or 'all', default: All ports
enable : Enable LLDP reception and transmission
disable: Disable LLDP
rx : Enable LLDP reception only
tx : Enable LLDP transmission only
(default: Show LLDP mode)
Default Setting:
disable
Example:
Enable port1 LLDP function.
-10020HP:/>lldp mode 1 enable
LLDP Optional TLV
Description:
Show or Set LLDP Optional TLVs.
Syntax:
LLDP O
ptional_T
L
V [<port_li
st>] [port
_descr
|sys_name|
sys_descr|
sys_cap
a|mgmt
_addr] [e
nable|disable]
Parameters:
<port_list>: Port list or 'all', default: All ports
port_descr : Description of the port
sysm_name : System name
sys_descr : Description of the system
sys_capa : System capabilities
mgmt_addr : Master's IP address
(default: Show optional TLV's configuration)
enable : Enables TLV
disable : Disable TLV
(default: Show optional TLV's configuration)
Default Setting:
Description of the port: Enable
System name: Enable
Description of the system: Enable
To Next Page
Loading...
Need help?
General