User’s Manual of WGSD-10020 Series
Default Setting:
disable
QoS DSCP EgressRemap
Description:
Set or show DSCP egress remap table. This table is used if the port egress remarking mode is 'remap' and the purpose is
to map the DSCP and DP level to a new DSCP value.
Syntax:
QoS DSCP EgressRemap [<dscp_list>] [<dpl_list>] [<dscp>]
Parameters:
<dscp_list>: DSCP (0-63, BE, CS1-CS7, EF or AF11-AF43) list or 'all'
<dpl_list> : DP level list or 'all', default: All DP levels (0-1)
<dscp> : Egress remapped DSCP: 0-63, BE, CS1-CS7, EF or AF11-AF43
QoS Storm Unicast
Description:
Set or show the unicast storm rate limiter.
Syntax:
QoS S
torm Unicast [e
nable|dis
able] [<p
acket_r
ate>]
Parameters:
enable : Enable unicast storm control
disable : Disable unicast storm control
<packet_rate>: Rate in fps (1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 32768k)
Default Setting:
disable
Example:
Enable unicast storm control in 2fps
-10020HP:/> QoS Storm Unicast enable 2
To Next Page
Loading...
Need help?
General