User’s Manual of WGSW-28040 / 28040P
179
4.14.5 Reboot Switch
The Reboot page enables the device to be rebooted from a remote location. Once the Reboot button is pressed, user have to
re-login the WEB interface about 60 seconds later, the Reboot Switch screen in Figure 4-14-5 appears.
Figure 4-14-5 Reboot Switch page screenshot
Buttons
: Click to reboot the system.
You can also check the SYS LED at the front panel to identify the System is load completely or not. If the SYS LED is off, then it
is in the firmware load stage; if the SYS LED light on, you can use the WEB browser to login the Switch.
To Next Page
Loading...
Need help?
General