User’s Manual of WGSW-28040 / 28040P
185
Global Config Mode
This mode permits the operator to make modifications to the running configuration. General setup commands are grouped in
this mode. From the Global Configuration mode, the operator can enter the Interface Configuration mode. The command
prompt at this level is:
Command Prompt: WGSW-28040(Config)#
From the Global Config mode, the operator may enter the following configuration modes:
6.1 User Mode Commands
6.1.1 Show Command
Show Version
Description:
Display software version
Syntax:
Show version
Example:
To display system version:
WGSW-28040> show version
PLANET v1.0 (WGSW-28040)
Copyright (C) 2011 Planet Technology Corporation.
WGSW-28040>
Show History
Description:
List the last several history commands
Syntax:
Show history
Example:
To display history:
WGSW-28040> show history
To Next Page
Loading...
Need help?
General