Planet WGSW-28040 - SNMP Host; Storm Control Command; Storm Control; Bandwidth Control Command

User’s Manual of WGSW-28040 / 28040P
250
SNMP Host
Description:
Set trap receiver IP address
Syntax:
snmp host <A.B.C.D> <name>
Parameters:
A.B.C.D : IP Address format is A.B.C.D where (A/B/C/D = 0 ~ 254)
name : Community name (length 1~16)
Example:
To set trap receiver IP address:
WGSW-28040(config)# snmp host 192.168.0.99 public
6.3.23 Storm Control Command
Storm Control
Description:
Set storm control configuration
Syntax:
storm-control port <port_list> <broadcast|multicast|unknown-unicast|unknown-multicast>
Parameters:
Port_list : Port list or 'all'
broadcast :Broadcast storm control
multicast :Multicast storm control
unknown-unicast :Unknown-unicast storm control
unknown-multicast :Unknown-multicast storm control
Example:
To set storm control configuration:
WGSW-28040(config)# storm-control port 1 unknown-multicast 100
6.3.24 Bandwidth Control Command
Port Bandwidth Control
Description:
Set port bandwidth control configuration