Planet WGSW-28040 - Ipv6 Command; Auto Configuration; Ipv6 Address

User’s Manual of WGSW-28040 / 28040P
270
6.3.42 IPv6 Command
Auto Configuration
Description:
Enable IPv6 auto-configuration
Syntax:
ipv6 auto-configuration
Example:
To enable IPv6 auto-configuration:
WGSW-28040(config)# ipv6 auto-configuration
IPv6 Address
Description:
Set IPv6 address
Syntax:
ipv6 address <ipv6_address> prefix <prefix>
Parameters:
Ipv6_address : IPv6 host address.
IPv6 address is in 128-bit records represented as eight fields of up to four hexadecimal digits with a colon
separates each field (:). For example, four hexadecimal digits with a colon separates each field (:). For
example, 'fe80::215:c5ff:fe03:4dc7'. The symbol '::' is a special syntax that can be used as a shorthand
way of representing multiple 16-bit groups of contiguous zeros; but it can only appear once. It also used a
following legally IPv4 address. For example,'::192.1.2.34'.
Prefix : IPv6 subnet mask , default: Show IPv6 prefix
Example:
To set IPv6 address:
WGSW-28040(config)# ipv6 address 2001::0001 prefix 64