User’s Manual of WGSW-28040 / 28040P
18
¾ Multicast
îš„ Supports IGMP Snooping v1, v2 and v3
îš„ Querier mode support
îš„ IGMP Snooping v2 fast leave
îš„ Unknown Multicast drop
¾ Security
îš„ Storm Control support
− Broadcast / Multicast / Unknown-Unicast / Unknown-Multicast
îš„ Authentication
− IEEE 802.1X Port-Based network access authentication
− Built-in RADIUS client to co-operate with the RADIUS servers
îš„ Access Control List
− IP-Based ACL
− MAC-Based ACL
îš„ MAC Security
− Static MAC
− Source / Destination MAC Filtering
− Port Security for Source MAC address entries filtering
¾ Management
îš„ Switch Management Interfaces
- Console / Telnet Command Line Interface
- IPv4 and IPv6 Web switch management
- SNMP v1, v2c switch management
- SSH / SSL secure access
îš„ Four RMON groups (history, statistics, alarms, and events)
îš„ SNMP trap for interface Link Up and Link Down notification
îš„ SNTP (Simple Network Time Protocol)
îš„ Built-in Trivial File Transfer Protocol (TFTP) client
îš„ BOOTP and DHCP for IP address assignment
îš„ Firmware upload/download via HTTP / TFTP
îš„ Event message logging to remote Syslog server
îš„ Reset button for system reboot or reset to factory default
To Next Page
Loading...
Need help?
General