User’s Manual of WGSW-28040 / 28040P
54
The page includes the following fields:
Object Description
• Target
The target of the log view entry. The following target types are supported:
RAM: Target the RAM of the log view .
Flash: Target the Flash of the log view.
• Severity
The severity of the log view entry. The following severity types are supported:
emerg: Emergency level of the system unsable for log view.
alert: Alert level of the immediate action needed for log view.
crit: Critical level of the critical conditions for log view.
error: Error level of the error conditions for log view.
warning: Warning level of the warning conditions for log view.
notice: Notice level of the normal but significant conditions for log view.
info: Informational level of the informational messages for log view.
debug: Debug level of the debugging messages for log view.
• Category
The category of the log view that are including:
ACL, Common, DAI, DEF_ENGINE, DoS, Dot1X, EEE, IGMP, L2, LACP, LLDP,
Log, Mirror, PoE, Port, QoS, QinQ , Rate, SNMP, STP, SVLAN, Switch, System,
TFTP, Trunk, UDLD, VLAN, LOOP_PROT
Buttons
: Click to view log.
Figure 4-2-17 Log Information page screenshot
The page includes the following fields:
Object Description
• Target
Display the current log target.
• Severity
Display the current log severity.
• Categery
Display the current log categery
• Total Entries
Display the current log entries
To Next Page
Loading...
Need help?
General