Chapter 1-First Time Installation and Configuration
Polycom, Inc. 1-33
9 Enter the required Gatekeeper information in the dialog box.
Table 1-8 Signaling Network Service – Gatekeeper Parameters
Field Description
Gatekeeper Select Specify to enable configuration of the gatekeeper IP address.
When Off is selected, all gatekeeper options are disabled.
Primary
Gatekeeper
IP Address or
Name
Enter either the gatekeeper’s host name as registered in the DNS or IP
address.
MCU Prefix in
Gatekeeper
Enter the number with which this Network Service registers with the
gatekeeper. This number is used by H.323 endpoints as the first part of their
dial-in string when dialing the MCU.
When PathNavigator or SE200 is used, this prefix automatically registers
with the gatekeeper. When another gatekeeper is used, this prefix must also
be defined in the gatekeeper.
Aliases:
Alias The alias that identifies the RMX’s Signaling Host within the network. Up to
five aliases can be defined for each RMX.
Note: When a gatekeeper is specified, at least one alias must be entered in
the table.
Additional aliases or prefixes may also be entered.
To Next Page
Loading...
