Printronix T6000 - Page 100

100
Application > Control > Active LP+ Emul
This function allows you to select the Active LinePrinter+ protocol. The LP+ is
used to print text or jobs that are not associated with any IGP emulation. Refer to
the LinePrinter Plus Programmer's Reference Manual for more information.
P-Series
Printronix P-Series language.
P-Series XQ
Printronix P-Series XQ language.
Serial Matrix
Emulates the Serial Matrix protocol.
Proprinter XL
Emulates the Proprinter XL protocol.
Epson FX
Emulates the Epson FX-1050 protocol.
Factory Default
P-Series
IMPORTANT
The LP+ emulation selections are NOT available in
the Postscript/PDF firmware.
Application > Control > PTX Setup SFCC
Allows you to choose the hex value of the ASCII character you wish to use
as the SFCC for the PTX SETUP command.
Minimum
hex 01
Maximum
hex FF
Factory Default
hex 21 or the “!” character
IMPORTANT
The PTX Setup SFCC menu is NOT available in the
Postscript/PDF firmware.