Application > Control > VGL Diagnostics
This menu sets the error reporting capability of VGL when selected as the
current Active IGP emulation.
Full error checking and report.
No error checking and report.
Command syntax is checked and error messages
printed when command parameters are incorrect.
Prints the following error markers for those elements
that print beyond the page boundaries:
>> For elements that begin off the right side of the
page.
<< For elements that begin at the indicated position but
end off the page.
For elements where the starting position of the
command contains an error other than an off-page
error.
Reports errors for elements that start or end beyond
the right edge of the page.
An error message will print when invalid barcode data
is encountered.
This is only shown when VGL is the Active IGP
Emulation.
Application > Control > XXX Diagnostics
This menu sets the error reporting capability of the Active IGP Emulation
(except PGL and VGL). “XXX” is used to denote the Active IGP Emulation
ZGL, TGL, IGL, STGL, DGL, MGL, or IEGL.
Full error checking and report.
No error checking and report.
For PGL, see PGL Diagnostics and for VGL, see
VGL Diagnostics instead.
To Next Page
Loading...
