Application > PGL Setup > Ignore Mode
This parameter instructs the IGP to ignore the character selected under the
Select Character menu.
The IGP does not ignore any characters.
The IGP ignores the character specified in the Select
Char menu.
Application > PGL Setup > Select Char
Instructs the IGP which decimal character (0-255) to ignore from the host.
Application > PGL Setup > Do FF at TOF
Determines whether the printer, with media already set at the TOF (Top-of-
Form) position, will advance media to the next TOF position upon receipt of
an FF command.
The printer will not advance media from the present
TOF position to the next TOF position upon receipt of
an FF command.
The printer will advance media from the present TOF
position to the next TOF position upon receipt of an FF
command, causing a blank form.
Application > PGL Setup > IGP100 Compatbl.
This parameter forces the output to correspond with IGP-100 line matrix
printer output in cases where there are differences.
In areas of conflict, the printer will be compatible with
legacy thermal products (best behavior).
The printer will match compatibility in all ways with
legacy line matrix products.
To Next Page
Loading...
