Application > VGL Setup > Ignore ^Lxx Cmd.
Controls how VGL handles form length commands.
The Form Length commands ^Lxx and ^Hxx will be
used from the VGL application.
The Form Length commands ^Lxx and ^Hxx will be
ignored, and the form length will be determined by
Application > LP+ Setup > Form Length (xx).
Application > VGL Setup > Midline PY
Controls whether the ^PY command will be allowed in the middle of a line.
The Graphics mode Enabled command, ^PY, must be
the first three characters of a line.
The ^PY or ^PN can occur anywhere in a line.
Application > VGL Setup > Width Limit
Controls the range of width for expanded characters based on the height.
There is no limit to width based on height.
The length and width for expanded characters is
shown in the Width Limit Table, which shows the
maximum width allowed for a specific height in the
range of 00 through 40 (0.0 through 4.0 inches).
To Next Page
Loading...
