Printronix T6000 - Page 131

131
Application > VGL Setup > UPC Descenders
Determines how descenders will be printed on UPC/EAN bar codes when
there is no human readable data included.
Disable
UPC/EAN bar codes are printed without descenders if
there is no human readable data.
Enable
UPC/EAN bar codes are printed with descenders,
even if there is no human readable data.
Factory Default
Enable
Application > VGL Setup > Select SO Char
Allows you to specify a decimal code from 0 through 255 to be used in place
of SO (Shift Out) as the control code which allows access for the alternate
set of control function characters for Code 128 barcodes. See the
description of the Code 128 barcodes in the VGL Programmer's Reference
Manual for details.
Minimum
0
Maximum
255
Factory Default
14
Application > VGL Setup > Rot. Char Size
Determines how expanded characters will be sized when rotated.
Adjusted
Rotated (clockwise/counterclockwise), expanded
characters have a different size than an unrotated
character with the same size parameters.
Not Adjusted
Rotated, expanded characters will be the same size as
unrotated characters with the same size parameters.
Factory Default
Adjusted
Application > VGL Setup > Ignore Spaces
Controls how trailing spaces are treated within alphanumeric elements.
Disable
Trailing spaces are not deleted from alphanumeric
elements in a graphics pass.
Enable
Trailing spaces are deleted from alphanumeric
elements in a graphics pass.
Factory Default
Disable