Printronix T6000 - Page 179

179
Host IO > Serial > Data Protocol
You can select one of the following serial interface protocols to meet the host
interface requirements,
Factory Default
XON / XOFF
Table 3. Response for Series1 Char
Printer State
Series1 1 Char
Response
Series1 2 Char
Response
ONLINE and Buffer Empty
CR
1 CR
ONLINE and Buffer Full
3
3 CR
OFFLINE and Buffer Empty
0
0 CR
OFFLINE and Buffer Full
2
2 CR
Table 4. Response for ENQ / ACK
Printer State
Status
ONLINE
40 06
ONLINE or Paper Motion Fault
43
Platen Open or Paper Out
47
Host IO > Serial > Data Term Ready
Stands for Data Terminal Ready. This configuration is part of hardware flow
control and determines when the Data Terminal Ready (DTR) signal is
generated. This signal indicates if the printer is ready to receive data.
True
Continuously asserts the DTR signal.
On-Line and
BNF
Asserts the DTR signal when the printer is ONLINE
and the internal serial buffer is not full (BNF).
Off-Line or BF
Asserts the DTR signal when the printer is OFFLINE or
the internal serial buffer is full.
On-line
Asserts the DTR signal when the printer is ONLINE.
False
Never asserts the DTR signal.
Factory Default
True