Printronix T6000 - Page 180

180
Host IO > Serial > Request to Send
This configuration is part of hardware flow control and determines when the
Request to Send (RTS) signal is generated. This signal indicates whether or
not the printer is ready to receive data.
True
Continuously asserts the DTR signal.
On-Line and
BNF
Asserts the DTR signal when the printer is ONLINE
and the internal serial buffer is not full (BNF).
Off-Line or BF
Asserts the DTR signal when the printer is OFFLINE or
the internal serial buffer is full
On-line
Asserts the DTR signal when the printer is ONLINE
False
Never asserts the DTR signal.
Factory Default
On-Line and BNF
Host IO > Serial > Poll Character
This option is for the Series1 protocol. Whenever the printer receives this
character, it sends a response to the host indicating the current state of the
printer.
Minimum
00 hex
Maximum
FF hex
Factory Default
00 hex
Host IO > Serial > Poll Response
This option is for the Series1 protocol. After receiving a poll character, the
printer will wait the poll response time in milliseconds before sending the
response.
Minimum
0 ms
Maximum
30 ms
Factory Default
0 ms