Printronix T6000 - Page 252

252
Table 13. LCD Message Troubleshooting
Displayed Message
Solution/Explanation
FILE SYS FULL
Delete Files
Insufficient flash memory available to store file. Given there is
512MB of Flash Memory, this error is still possible but unlikely.
1. Go to the System > Flash File Edit section of the menu.
2. Check the amount of flash memory that can be optimized from
the “Flash Reclaimable” menu.
3. If this value is small, then use “Delete Files” to delete
unwanted files.
4. If this value is large, then run “Optimize & Reboot”.
FILE SYS FULL
Optimize&Reboot
File system not detected or flash was corrupted.
1. Run the System > Flash File Edit > Optimize & Reboot
feature.
FILE SYS INVALID
Optimize&Reboot
The file system was given an invalid request.
1. Run the System > Flash File Edit > Optimize & Reboot
feature.
FILE SYS WRITE
Check Flash
Problem writing to flash memory.
1. Power off the printer for 15 seconds, then power back on. If
the problem persists, contact your authorized customer
service representative.
FILE UPLOADING
Please Wait
File is uploading to PNE.
1. Wait for upload completion before accessing printer front
panel.
FPGA FILE NOT FOUND
The program file was not downloaded successfully.
1. Download the program file again.
2. If the message reappears, contact your authorized customer
service representative.
FRAMING ERROR
Serial framing error over a serial interface.
1. Match the serial interface settings of the printer to those of the
host computer.