The Print Speed or
Slew Speed value is
above 6 IPS as the
power-up default with
the validator option
installed, or the user
attempted to increase
Print Speed or Slew
Speed above 6 IPS.
1.
Change the Media > Speed > Print Speed or
Slew Speed to 6
IPS or less when using the
Validator option, and save the
new value as the power-up
default.
Data validation error:
missing barcode.
1.
Check the paper and ribbon for
cleanliness, wrinkles, etc., or
an obstructed validator beam.
If there is no validator beam at
all, or if the LED is not flashing
as barcodes pass through the
validator beam, recycle
validator power. If the problem
persists, contact your service
representative.
NOTE: xx represents the number of missing
barcodes (on the
form)
that caused the
warning/fault to be
declared.
The Validator > Control > Validator Active =
Enable, but
when the
printer was
first powered up it
could not communicate
with the
validator.
1.
Check that the validator signal
cable is securely connected
to
the validator unit.
To Next Page
Loading...
