3. Installation and setup ABL800 FLEX Operator's Manual
Parameters and input setup, Continued
Parameters can be locked/unlocked from the RADIANCE system.
To lock or unlock a parameter from the analyzer, do the following:
Parameters
(continued)
Step Action
1.
Make sure the analyzer is not connected to the RADIANCE system.
Highlight a parameter on the screen, using the scroll facilities.
Press Lock/Unlock. (This button is grayed out if the analyzer is
connected to the RADIANCE system.)
The locked parameter will show red on the parameter bar and will
change the overall analyzer status traffic light on the Analyzer Status
button to red. The parameter value will be absent from the printout.
However, the locked parameter will be calibrated.
2.
To unlock a parameter, highlight it and press Lock/Unlock. The traffic
light on the Analyzer Status button will change from red to a color
corresponding to the analyzer’s overall status.
3.
To edit the parameter setup, do the following.
Step Action
1.
Highlight the desired parameter and press Edit.
2.
Activate (or deactivate) the following check buttons to select (or
deselect) the following functions:
Highlighted
parameter
Continued on next page
3-56
To Next Page
Loading...
Need help?
General
