ABL800 FLEX Operator's Manual 3. Installation and setup
Analyzer settings, Continued
Time/Date setup
This program allows you to change the current time and date setting.
To reset the time and date, do the following:
Step Action
1.
Highlight the "Time" box by touching it on the screen.
2.
Key in the time on the screen keypad. Confirm with Enter.
A separator is automatically added between hours, minutes and
seconds.
3.
Repeat steps 1-2 to reset the Date.
To revert to the previous settings, press Current.
4.
Acoustic signal
setup
This program allows you to set up a short beep to sound after certain events.
To activate the acoustic signal, do the following:
Step Action
1.
Activate the desired check button(s).
2.
Select volume for the acoustic signal or activate the "Mute all acoustic
signals" check button.
Continued on next page
3-65
To Next Page
Loading...
Need help?
General
