3. Installation and setup ABL800 FLEX Operator's Manual
Analyzer settings, Continued
Acoustic signal
setup
(continued)
The following events are available:
Event Explanation
Value exceeds critical
range
One of the measured values exceeds the specified
critical limits for that parameter.
Close inlet The inlet should be closed.
Result is ready A sample has been analyzed and the results are ready for
viewing.
Inlet is open too long The inlet should be closed.
Beep before
AutoCheck opens
A beep sounds to indicate that an AutoCheck
measurement is about to take place.
Language
This program allows you to select a language of your choice from the list of
languages available on your analyzer.
To change to another language do the following:
Step Action
1.
Select the desired language with the arrow buttons.
Press Set Language.
Press Continue to continue or press Cancel to continue operating the
analyzer with the language unchanged.
2.
Continued on next page
3-66
To Next Page
Loading...
Need help?
General
