ABL800 FLEX Operator's Manual 3. Installation and setup
Communications, Continued
Automatic Data
Transmission
Setup
This program allows you to set up automatic sending of data to a connected
LIS/HIS computer system or to the RADIANCE system.
To select the settings, do the following:
Step Action
1.
Highlight a desired connection device on the screen, using the
up/down arrows (note that the "FLEXQ Sample Status" is not
available if connection to the RADIANCE system has been selected).
2.
Activate the relevant check button(s) to select the data to be sent to the
highlighted connection.
NOTICE: If the requested patient data (e.g. Patient Last Name) was received after
exiting the Patient Identification screen, the patient report will be transmitted
without the requested data. To prevent this, select one of the patient data items
transferred from LIS/HIS as mandatory.
Patient Lookup
Setup
This program allows you to select the data source in order to obtain the patient
information on the Patient Identification screen.
To select the settings, do the following:
Step Action
1.
Select a data source from the established connections (local database,
RADIANCE or LIS/HIS).
Continued on next page
3-75
To Next Page
Loading...
Need help?
General
