RADIOMETER ABL800 FLEX - Page 210

7. Replacements ABL800 FLEX Operator's Manual
General information, Continued
Recording
replacements in
Hold mode
(continued)
Step Action
7.
(conti-
nued)
(In case only the Crea electrodes were remembraned or replaced, the
Confirm Membrane Replacement screen will be used.)
Press Accept to start the restarting sequence or press Back to return to
the previous screen.
After the required action is completed, press Restart and then Accept.
Entering Fluid
Replacements
mode
The Fluid Replacements mode ensures that the proper restart sequence will follow
the exit from this mode.
To enter the Fluid Replacements mode, do one of the following:
• Press Analyzer Status – Reagents – Replace.
• Remove a solution container
Recording
replacements in
the Fluid
Replacements
mode
To record replacements in the Fluid Replacements mode, do the following:
Step Action
1.
Press Analyzer Status – Reagents – Replace.
2.
Remove the component to be replaced according to recommended
procedure.
Continued on next page
7-4