RADIOMETER ABL800 FLEX - Page 255

ABL800 FLEX Operator's Manual 9. Data management
Patient Profiles Log, Continued
Adding a new
patient profile
To add a new patient profile, do the following:
Step Action
1.
Press Add New to display the screen below.
2.
Use a barcode reader to scan the patient data supported by the barcode
(the "Enable General Barcode Support" should be activated in the
Miscellaneous Setup) – see the procedure in Entering information
with barcode reader in chapter 4, section Patient identification.
Or request (if connected) the data from LIS/HIS by verifying the
patient ID and pressing the Request button.
3.
To edit data on the screen, highlight an item, using the arrow buttons
and type in the data, using the screen keyboard or keypad.
Confirm each entry with Enter.
4.
When completed, press Back to return to the previous screen.
Deleting a
patient profile
To delete a patient profile from the log, do the following:
Step Action
1.
Highlight the desired patient profile.
2.
Press Remove.
Continued on next page
9-9