ABL800 FLEX Operator's Manual 9. Data management
Quality Control Log, Continued
Filter/trend
function
(continued)
Step Action
5.
When all the criteria have been selected, press Apply to make the
search.
Press Trend to select the parameters.
6.
Select the desired parameter(s) by activating the check buttons (e.g.
pH, pCO
2
, pO
2
).
Press View Trend.
7.
The trend of the selected parameter(s) is displayed.
To view the filter criteria, press the View Filter (the criteria cannot be
changed, only viewed).
To print the displayed trend, press Print.
To return to the screen in step 5, press Back.
Viewing quality
control statistics
Only those measurement values that fall within the statistical range are included in
the statistical data. Therefore parameters outside the measuring range or with a "?"
are not included.
Parameter
•
The screen shows statistics for each control solution (identified by its slot,
type and lot number) for a single parameter.
Press Next param.. or Prev. param.. to view other parameters.
•
Press WDC Report to create a WDC Report – see Creating a WDC Report
in chapter 8.
Continued on next page
9-13
To Next Page
Loading...
