ABL800 FLEX Operator's Manual 15. Radiometer settings
15-11
Radiometer default settings, Continued
Default settings for User-defined Patient Data Items are as follows:
Name Type Unit Decimals
Spontaneous RR Numerical b/min 1
Set RR Numerical b/min 1
Vt Numerical L 2
Ve Numerical L 2
Peak Flow Numerical L/min 1
Liter Flow Numerical L/min 1
Ti Numerical seconds 1
PEEP Numerical cmH
2
O 1
Pressure Support Numerical cmH
2
O 1
CPAP Numerical cmH
2
O 1
CMV Numerical Rate 1
SIMV Numerical Rate 1
Flow-by Numerical L/min 1
HFV Numerical Rate 1
I:E Ratio Numerical 2
Wave Numerical None
ICD9 Code Numerical None
Oxygen Device 1 Numerical None
Oxygen Device 2 Numerical None
Diagnostic Code Numerical None
Default settings for User-defined Notes: No notes defined.
Default settings for Language: English.
Default settings for Acoustic Signals are as follows:
Event Default setting
Value exceeds critical limits No
Close inlet Yes
Result is ready Yes
Inlet is open too long Yes
Beep before AutoCheck opens Yes
Continued on next page
General Setup
defaults
(continued)
To Next Page
Loading...
