Configuration
CS210 Rev. B4 Feb 2015 51
It is not possible to add, edit or delete any alarm from this repository. Alarms are
periodically and automatically erased based on the settings in the Historical
Management under
<Others> Tab, page 44!
6.2.13.2 Alarms detail
Click
ing
th
e <Look
up> b
utt
on in
the
<Rep
ositor
y of er
ror
s> v
iew w
ill la
un
ch th
e <Alar
m de
tail> v
iew
.
In the <Alarm detail> you can see all details for each single alarm: the period of time that the alarm
existed (there’s a chance that it’s still active), which device experienced the alarm, the type of alarm,
registered temperature, a brief comment about the problem and its control status (the user, the date
and the comment).
Figure 45: Alarms detail
6.2.13.3 Alarms list
Using this screen you can print reports of all alarms registered in the system. These lists or reports are
fully configurable by using selection filters and sorting criteria.
Selection filters allow filtering information using:
• Alarm identifier
• Starting date
• Ending date
• State
• Control
To Next Page
Loading...
