Options
80 Rev. B4 Feb 2015 CS210
9. Options
9.1 Start-up-Service
The start-up service includes the installation of the scanners into the protective housing boxes,
checking all wiring, communications and services from the scanners to the location of the computer.
The scanner alignment will be checked and corrected as necessary. Software will be installed, and all
users will be trained on the full operation of the system, including routine maintenance procedures.
The entire system will be operational before the final acceptance and sign-off by the customer. Raytek
does not provide construction, erection, mechanical, electrical or building services. Prior to the start-
up service the scanner housings should be installed in the designated locations per our
recommendations. All wiring should be in place and the associated electronics positioned in the
control room. Raytek will check the final connections and power the system. The scanner heads
should not be put into the protective housings until this start-up service begins.
The startup
service option is not included in the CS210 standard package, it must be
ordered as a separate line item!
To Next Page
Loading...
