Appendix
110
9
âť–
âť–âť–
âť– ADF or ARDF
Limitation
âť’ There may be a difference in the size of the image when it is printed at the des-
tination.
âť’ If you place an original larger than A3, 11"Ă—17" on the exposure glass, only an
A3, 11"Ă—17" area is scanned.
Note
âť’ Even if an original is correctly placed on the exposure glass or in the
ADF/ARDF, a vertcal margin of 3 mm (0.1") and a horizontal margin of 2 mm
(0.8") may not be sent.
âť’ The machine detects paper sizes in the following ways:
• When you place an original in the ADF or ARDF, an original wider than
about 264 mm (10.4") is scanned as A3, 11"Ă—17" size.
An original narrower than about 230 mm (9.1") will be sent as 8
1
/
2
"Ă—11" or
8
1
/
2
"×14" size, and an original narrower than about 264 mm (10.4”) is
scanned as B4 JIS.
Originals up to 1,200 mm (47.2") in length can be scanned.
• Refer to the table below for sizes the machine can detect when you place
an original on the exposure glass. Because the machine scans non-standard
size documents in a standard size, part of the image may be truncated de-
pending on the length of the document.
âť–
âť–âť–
âť– Metric Version
Length
*1
-249 mm 249 mm-274 mm 274 mm-316 mm 316 mm-
Width
-243 mm
Ă—
B5 JIS
L
A4
L
F
L
243 mm-
268 mm
B5 JIS
K
B4 JIS
L
B4 JIS
L
B4 JIS
L
268 mm- A4
K
A3
L
A3
L
A3
L
Kir-C2-AEcombine_F_FM.book Page 110 Monday, September 29, 2003 11:39 AM
To Next Page
Loading...
Need help?
General
