Trouble-
shooting
FIRMWARE HISTORY
SM 4-13 B039/B040/B043
DESCRIPTION OF MODIFICATION FIRMWARE
LEVEL
SERIAL
NUMBER
FIRMWARE
VERSION
When turning on/off main switch during the
combine copy, SC 922 may appear.
The range of the value for SP1-105 has been
changed as follows (Service Manual is correct):
OLD: 160 ~ 230 °C
NEW: 160 ~ 190 °C
The message when trying to sort by using long
length original has been changed as follows:
OLD: Cannot Sort This Size Paper
NEW: Cannot Sort This Paper Size
The message when trying to make a duplex
copy by using 51/2”x81/2” paper size has been
changed as follows:
OLD: Cannot Duplex Copy / This Size Paper
NEW: Cannot Duplex Copy / This Paper Size
B0395531 D
June 2001
production
1.23
Corrects the following:
The default value for SP2-101-002 (Erase
Margin Adjustment - Leading edge) has been
changed from 4.0 to 3.0.
The default value for SP2-101-001 (Erase
Margin Adjustment - Leading edge) has been
changed from 3.0 to 2.0.
After SP2-995 (ID Sensor Detection Interval) is
set to 256 or higher, the incorrect value is
displayed.
B0395531 E
Oct. 2001
Production
1.30
Corrects the following:
When the machine exits Low Power Mode,
the Paper End LED may not turn on even
when there is no paper remaining. This
occurs when the customer has selected
Printer as the preferential application.
The cooling fan sometimes does not stop
when the machine enters Night/Off Mode
from the Low Power Mode Level 1.
B0395531 F
April. 2002
Production
1.32
⇒
Rev. 11/2002
To Next Page
Loading...
