ENERGY SAVER MODES
B039/B040/B043 6-74 SM
Returning to Stand-by Mode
If one of the following is done, the machine returns to standby mode:
• Operation switch is pressed
• An original is placed in the ADF
• The platen cover or ADF is lifted
• The machine receives the wake-up signal from a PC (Smart Net Monitor)
• An error or SC condition occurs
6.15.3 NIGHT/OFF MODE
This is used instead of auto off mode when an optional fax and/or printer unit is
installed.
If the customer selects the Low Power Mode Level 3 with UP mode (User Tools -
System Settings - Energy Saver Level), this is the same condition as night/off
mode, except that the main power switch does not turn off in low power mode.
Entering Night/Off Mode
The machine enters night/off mode when:
• The auto off timer has expired following the last time engine components or
sensors were active (e.g. end of a copy job, platen cover lifted, key pressed, etc).
User Tools—System Settings—Auto Off Timer
The default setting is 30 min
If the energy saver timer setting is greater than the auto off timer setting, the
machine will enter night/off mode (rather than low power mode) when the auto off
timer runs out after the end of the job.
To Next Page
Loading...
