Ricoh B039 - Changing the Original Sensor Positions (8 K;16 K)

Replacement
Adjustment
SCANNER SECTION
SM 3-13 B039/B040/B043
3.4.6 CHANGING THE ORIGINAL SENSOR POSITIONS (8K/16K)
This procedure is for China models only. To enable detection of the following
original sizes, the original sensors must be moved from their factory-set positions
to the locations indicated in the drawing below right.
• 8K SEF (270 x 390 mm)
• 16K SEF (195 x 270 mm)
• 16K LEF (270 x 195 mm)
Once the sensors have been moved, they will detect paper sizes as follows.
Length Sensors Width SensorsOriginal Size
L1 L2 W1 W2
8K-SEF
❍❍❍✗
16K-SEF
❍✗✗✗
16K-LEF
✗✗❍✗
❍: Original present ✗: Original not present