BIT SWITCHES
B404 5-12 SM
System Switch 00
No FUNCTION COMMENTS
5 G3 communication parameter
display
0: Disabled
1: Enabled
This is a fault-finding aid. The LCD shows the key
parameters (see the next page). This is normally
disabled because it cancels the CSI display for the
user.
Be sure to reset this bit to 0 after testing.
6 Protocol dump list output after
each communication
0: Off
1: On
This is only used for communication
troubleshooting. It shows the content of the
transmitted facsimile protocol signals. Always reset
this bit to 0 after finishing testing.
The setting of system switch 09 bit 6 determines the
types of communication that the list is printed after.
7 Not used Do not change the setting.
To Next Page
Loading...
