Fax Unit B404
SERVICE RAM ADDRESSES
SM 5-61 B404
6800C1(H) - User parameter switch 01 (SWUSR_01)
Bit 0: Label insertion home position 0: Disabled, 1: Enabled
Bit 1: Not used
Bit 2: Automatic reduction (tx) home position 0: Disabled, 1: Enabled
Bits 3 and 4: Scanning mode LED home position
(This switch is not printed on the user parameter list.)
Bit 4 3 Setting
00Text
01Not used
1 0 Photo
1 1 Special Original (See the note below)
NOTE: The “Special Original” setting is not explained in the Operator’s Manual,
because it can be selected only if System Switch 19 – bit 7 is set to “1”.
Bit 5: TTI print home position 0: Disabled, 1: Enabled
Bit 6: Not used
Bit 7: Settings return to home position after scanning 0: Disabled, 1: Enabled
6800C2(H) - User parameter switch 02 (SWUSR_02)
Bit 0: Forwarding mark printing on forwarded messages 0: Disabled, 1: Enabled
Bit 1: Center mark printing on received copies
(This switch is not printed on the user parameter list.)
0: Disabled, 1: Enabled
Bit 2: Reception time printing
(This switch is not printed on the user parameter list.)
0: Disabled, 1: Enabled
Bit 3: TSI print on received messages 0: Disabled, 1: Enabled
Bit 4: Checkered mark printing
(This switch is not printed on the user parameter list.)
0: Disabled, 1: Enabled
Bits 5 and 7: Not used
6800C3(H) - User parameter switch 03 (SWUSR_03: Automatic report
printout)
Bit 0: Transmission result report (memory transmissions) 0: Off, 1: On
Bit 1: Not used
Bit 2: Memory storage report 0: Off, 1: On
Bit 3: Polling reserve report (polling reception) 0: Off, 1: On
Bit 4: Polling result report (polling reception) 0: Off, 1: On
Bit 5: Transmission result report (immediate transmissions) 0: Off, 1: On
Bit 6: Not used
Bit 7: Journal 0: Off, 1: On
To Next Page
Loading...
