FIRMWARE HISTORY
B404 8-2 SM
B404 FIRMWARE MODIFICATION HISTORY
Rev. 10/2002
DESCRIPTION OF MODIFICATION
FIRMWARE
LEVEL
SERIAL
NUMBER
FIRMWARE
VERSION
The image in the area 3cm from the leading edge
is sometimes printed again near the middle of the
page.
The wording for “Quick Dial Label” in the Czech
display language has been corrected as follows:
Incorrect: Štítek Blesk.
Correct: Štítek Blesk .Vol.
The wording for “Select Sender with” in the Danish
display language has been corrected as follows:
Incorrect: Vælg modtager Bladre
Correct: Vælg sender med
The wording for “Extension Outside” in the Dutch
display language has been corrected as follows:
Incorrect: Intern Buiten
Correct: Intern Externe
The wording for “Select Sender with” in the
Norwegian display language has been corrected as
follows:
Incorrect: Velg mottaker Se igjen.
Correct: Velg mottaker med
B4045582E Oct ’01
Production
05.01.00
If the machine receives an incoming MMR
transmission following an interrupted non-ECM job,
a blank page is sometimes printed out.
ADDRESS appears on the Journal where DATE
and TIME are normally written.
B4045582F Marc h ’01
Production
06.05.00
To Previous Page
Loading...
