Sets the communication test call.
[Disable/ Enable]
Sets the machine information notice.
[Disable/ Enable]
Supply Auto
Ordering Call
Sets the supply auto ordering call.
[Disable/ Enable]
Displays the ID2 code (ASCII 17digits).
Performs the CE Call at the start or end of the service. [OK
/Back]
Enables or disables the remote service function.
[Disable/ Enable]
Executes the communication test. [OK /Back]
Displays the RCG registration status.
[0 to 2 / 0 / 1/step]
Displays the URL for RCG center.
Sets the polling interval.
[0 to 4294967295 / 60 / 1 sec/step]
Specifies the connect timeout interval when calling the RCG.
[1 to 90 / 30 / 1 sec/step]
Specifies the send timeout interval when calling the RCG.
[0 to 100 / 30 / 1 sec/step]
Specifies the receive timeout interval when calling the RCG.
[0 to 100 / 30 / 1 sec/step]
If the HTTP connection fails, specify the interval at which the
connection will be retried again.[0 to 65535 / 3 / 1 sec/step]
If the HTTP connection fails, specify the number of times to
retry the connection.
[0 to 255 / 3 / 3 counts/step]
Specifies the connection request sending delay.
[0 to 255 / 5 / 1 sec/step]
Specifies the maximum number of multipart.
[0 to 10 / 10 / 1/step]
Sets the periodic notification mode.
[0 to 5 / 0 / 1/step]