4.Replacement and Adjustment
64
ITB Cleaning Unit
The ITB cleaning unit contains waste toner. When removing the ITB cleaning unit, put it on a sheet of
paper.
1. Remove the image transfer belt unit. (Image Transfer Belt Unit)
2. Release each hook and bushing and remove the left handle [A] and right handle [B].
3. Remove the ITB cleaning unit [C]. ( × 2)
Waste Toner Collection Motor (M7)
1. Remove the rear cover. (Rear Cover)
2. Remove the operation panel. (Operation Panel)
3. Remove the right cover. (Right Cover)
To Next Page
Loading...
