Rohde & Schwarz ESW Series - Page 125

Measurements and Result Displays
R&S
®
ESW
125User Manual 1177.6298.02 ─ 08
Figure 9-12: Overview of the "Peak Search" configuration
The remote commands required to configure the peak search are described in Chap-
ter 15.5.7, "Peak Search", on page 462.
Selecting the peak search method..............................................................................125
Controlling the size of the peak list............................................................................. 125
Defining peak characteristics...................................................................................... 126
Selecting a limit line.................................................................................................... 126
Enabling and disabling limit checks............................................................................ 126
Selecting the peak search method
Selects the peak search mode.
More information.
"Peaks"
Looks for a particular number of peaks over the complete scan range.
"Subranges"
Divides the scan range into smaller, equidistant subranges and looks
for a particular number of peaks in each subrange.
Remote command:
CALCulate<n>:PEAKsearch:METHod on page 465
Controlling the size of the peak list
Defines the number of peaks that are transferred to the peak list.
The contents of the peak list depend on the selected search mode.
●
"Peaks"
When you have selected the "Peaks" search mode, define the number of peaks
the R&S ESW looks for during a peak search.
The range is from 1 to 500 peaks.
●
"Subranges"
Test Automation