Rohde & Schwarz ESW Series - Page 465

Remote Commands in the Receiver Application
R&S
®
ESW
465User Manual 1177.6298.02 ─ 08
CALCulate<n>:PSEarch:MARGin <Margin>
CALCulate<n>:PEAKsearch:MARGin <Margin>
This command defines the limit line margin that is considered during a peak search.
Suffix:
<n>
.
irrelevant
Parameters:
<Margin> Default unit: dB
Example: //Define a limit line margin
CALC:PEAK:MARG 2
Manual operation: See "Defining peak characteristics" on page 126
CALCulate<n>:PSEarch:METHod <Method>
CALCulate<n>:PEAKsearch:METHod <Method>
This command selects the way the R&S ESW creates a peak list.
Suffix:
<n>
.
irrelevant
Parameters:
<Method> SUBRange
Divides the scan range into smaller subranges and looks for a
particular number of peaks in each subrange.
PEAK
Looks for a particular number of peaks over the complete scan
range.
*RST: PEAK
Example: //Divide the scan range into smaller subranges for the peak
search
CALC:PEAK:METH SUBR
Manual operation: See "Selecting the peak search method" on page 125
CALCulate<n>:PSEarch:SUBRanges:PCOunt <Peaks>
CALCulate<n>:PEAKsearch:SUBRanges:PCOunt <Peaks>
This command defines the number of peaks to be found in each subrange.
Prerequisites for this command
●
Select subrange peak search mode (CALCulate<n>:PEAKsearch:METHod).
●
Define number of subranges (CALCulate<n>:PEAKsearch:SUBRanges[:
VALue]).
Suffix:
<n>
.
irrelevant
Measurements and Result Displays