Rohde & Schwarz ESW Series - Page 464

Remote Commands in the Receiver Application
R&S
®
ESW
464User Manual 1177.6298.02 ─ 08
Example: //Add a frequency to the peak list
CALC:PEAK:ADD 93MHz
Usage: Setting only
Manual operation: See "Editing a peak list" on page 128
See "Adding the current frequency to the peak list" on page 128
CALCulate<n>:PSEarch:AUTO <State>
CALCulate<n>:PEAKsearch:AUTO <State>
This command turns an automatic test sequence on and off.
An automated test sequence includes a scan and a peak search, but no final measure-
ment.
Suffix:
<n>
.
irrelevant
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF
Example: //Turn on the automated peak search
CALC:PEAK:AUTO ON
CALCulate<n>:PSEarch:CLEar[:IMMediate]
CALCulate<n>:PEAKsearch:CLEar[:IMMediate]
This command deletes the contents of a peak list.
Suffix:
<n>
.
irrelevant
Example: //Clear the peak list
CALC:PEAK:CLE
Usage: Event
Manual operation: See "Editing a peak list" on page 128
CALCulate<n>:PSEarch[:IMMediate]
CALCulate<n>:PEAKsearch[:IMMediate]
This command initiates a peak search.
Suffix:
<n>
.
irrelevant
Example: //Initiate a peak search
CALC:PEAK
Usage: Event
Measurements and Result Displays