Rohde & Schwarz ESW Series - Page 240

Common Analysis and Display Functions
R&S
®
ESW
240User Manual 1177.6298.02 ─ 08
11.5.1.2 Display Line Settings
Access: "Overview" > "Analysis" > "Lines" > "Display Lines"
Two vertical and two horizontal lines can be defined in the display.
Vertical Line <x>..........................................................................................................240
Horizontal Line 1/ Horizontal Line 2............................................................................ 240
Tuned Frequency........................................................................................................ 240
Vertical Line <x>
Activates a vertical display line in the diagram at the specified point of the x-axis,
depending on the scale of the axis.
If you activate both vertical lines, the label of the first vertical line shows the distance to
second vertical line.
Remote command:
CALCulate<n>:FLINe<dl> on page 561
CALCulate<n>:TLINe<dl> on page 562
Horizontal Line 1/ Horizontal Line 2
Activates a horizontal display line (H1 or H2) in the diagram at the specified point of the
y-axis.
If you activate both horizontal lines, the label of the first horizontal line shows the dis-
tance to second vertical line.
Remote command:
CALCulate<n>:DLINe<dl> on page 560
CALCulate<n>:DLINe<dl> on page 560
Tuned Frequency
Turns a display line that represents the currently selected receiver frequency on and
off.
The tuned frequency line is labeled "TF" in the diagram.
Remote command:
CALCulate<n>:TFLine:STATe on page 562
11.5.1.3 Defining Display Lines
1. Display lines are configured in the "Lines Config" dialog box. To display this dialog
box, press the [Lines] key and then "Lines Config".
Display and Limit Lines