Rohde & Schwarz ESW Series - Page 473

Remote Commands in the Receiver Application
R&S
®
ESW
473User Manual 1177.6298.02 ─ 08
[SENSe:]DETector<t>:FMEasurement <Detector>
This command selects the detector for the final measurement.
Suffix:
<t>
.
Trace
Parameters:
<Detector> AVERage
Selects the Average detector.
CAVerage
Selects the CISPR Average detector.
CRMS
Selects the CISPR RMS detector.
NEGative
Selects the Min Peak detector.
NONE
Ignores the corresponding trace during the final measurement.
POSitive
Selects the Max Peak detector.
QPEak
Selects the Quasipeak detector.
RMS
Selects the RMS detector.
*RST:
QPEak
Example: //Select final measurement detector
DET:FME POS
Manual operation: See "Detector" on page 133
[SENSe:]FMEasurement:AUTO <State>
This command turns a full automated test sequence on and off.
A full automated test sequence includes a scan, a peak search and a final measure-
ment.
Parameters:
<State> ON | OFF | 1 | 0
*RST: ON
Example: //Turn on automated test sequence.
FME:AUTO ON
Manual operation: See "Interactive" on page 133
[SENSe:]FMEasurement:TIME <Time>
This command defines the time each frequency in the peak list is measured during the
final measurement.
Measurements and Result Displays