Rohde & Schwarz ESW Series - Page 518

Remote Commands in the Receiver Application
R&S
®
ESW
518User Manual 1177.6298.02 ─ 08
DISPlay[:WINDow<n>]:SIZE <Size>
This command maximizes the size of the selected result display window temporarily.
To change the size of several windows on the screen permanently, use the LAY:SPL
command (see LAYout:SPLitter on page 521).
Suffix:
<n>
.
Window
Parameters:
<Size> LARGe
Maximizes the selected window to full screen.
Other windows are still active in the background.
SMALl
Reduces the size of the selected window to its original size.
If more than one measurement window was displayed originally,
these are visible again.
*RST: SMALl
Example:
DISP:WIND2:SIZE LARG
15.7.1.2 Screen Layout
The following commands are required to change the evaluation type and rearrange the
screen layout for a measurement channel as you do using the SmartGrid in manual
operation. Since the available evaluation types depend on the selected application,
some parameters for the following commands also depend on the selected measure-
ment channel.
Note that the suffix <n> always refers to the window in the currently selected measure-
ment channel.
LAYout:ADD[:WINDow]?................................................................................................. 518
LAYout:CATalog[:WINDow]?............................................................................................519
LAYout:IDENtify[:WINDow]?............................................................................................ 520
LAYout:REMove[:WINDow]............................................................................................. 520
LAYout:REPLace[:WINDow]............................................................................................ 520
LAYout:SPLitter..............................................................................................................521
LAYout:WINDow<n>:ADD?............................................................................................. 522
LAYout:WINDow<n>:IDENtify?........................................................................................ 523
LAYout:WINDow<n>:REMove..........................................................................................523
LAYout:WINDow<n>:REPLace........................................................................................ 523
LAYout:ADD[:WINDow]? <WindowName>,<Direction>,<WindowType>
This command adds a window to the display in the active channel.
This command is always used as a query so that you immediately obtain the name of
the new window as a result.
To replace an existing window, use the LAYout:REPLace[:WINDow] command.
Analysis